Installing the Rear Roller (continued)
Cutting Deck: Service and Repairs
the roller should be 0.5 to 1.0 mm (0.020 to 0.040 inch). Torque the bolts
to 41 N∙m (30 ft-lb).
6. Install and tighten the fasteners that secure each end of the roller to the roller
mounts. Torque the roller shaft screws (item 4 in
8 in
Figure
234) to 40 to 47 N∙m (29 to 35 ft-lb).
7. After you complete the assembly, raise and lower the cutting deck to check
that the hydraulic hoses and fittings do not contact anything.
Page 7–16
Figure
234) and bolts (item
Groundsmaster
®
16226SL Rev C
4300-D