Toro Groundsmaster 4300-D Service Manual page 348

Disassembling the Control Arm
Assembling the Control Arm
Chassis: Service and Repairs
g185936
1. Foam seal
1. Park the machine on a level surface, lower the cutting decks, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Disconnect the negative battery cable from the battery; refer to
Battery (page 5–94).
3. Loosen the 2 swell latches (item 13 in
cover from outside of the control arm.
4. At the front of the control arm, remove the screw (item 11 in
locknut that secure the control arm covers to each other.
5. Remove the 5 washer-head screws (item 15 in
cover to the control arm.
6. Remove the control arm covers from the machine. As the left control arm
cover (item 32 in Figure
wire harness connector from the headlight switch.
7. Remove the electrical components from the control arm as necessary
213).
1. Install all the electrical components that were removed from the control arm
(Figure 213).
2. Position the covers to the control arm. As the left control arm cover (item 32
in Figure 213) is placed, connect the wire harness connector to the headlight
switch. Also, ensure that the platform wire harness is routed correctly
through the cover openings and the harness foam seal is captured between
the control arm covers
3. Secure each cover to the control arm with the 5 washer-head screws (item
15 in Figure 213). Install the screw (item 11 in
secure the covers at the front of the control arm.
4. Install the access cover to outside of the control arm.
5. Connect the negative battery cable to the battery; refer to
Battery (page 5–94).
Figure 214
2. Platform wire harness
Figure
213) is removed from the control arm, disconnect the
(Figure 214).
Page 6–24
Servicing the
213) and remove the access
Figure 213) and
Figure 213) that secure each
Figure 213) and locknut to
Servicing the
Groundsmaster
16226SL Rev C
(Figure
® 4300-D