Toro Groundsmaster 4300-D Service Manual page 350

Removing the Operator Seat
Chassis: Service and Repairs
The operator seat, seat base, and control arm assembly are attached
to the machine with the same fasteners. Support the seat base and
control arm to prevent them from shifting when removing the seat.
Damage to the control arm electrical components and platform
wiring harness can occur if the seat base and control arm are not
properly supported during seat removal.
g185935
1. Platform wire harness
2. Flange-head screw (2 each)
g185921
1. Seat base
2. Control arm
3. Bushing (2 each)
1. Park the machine on a level surface, lower the cutting decks, shut off the
engine, set the parking brake, and remove the key from the key switch.
IMPORTANT
Figure 216
3. Seat switch connector
Figure 217
4. Retainer bracket
5. Flat washer (2 each)
6. Flange-head screw (2 each)
Page 6–26 Groundsmaster ® 4300-D
16226SL Rev C