Removing The Screws Of An Expansion Enclosure Assembly - IBM Storwize V7000 Unified Problem Determination Manual
Hide thumbs
Also See for Storwize V7000 Unified:
- Introduction and implementation manual (670 pages) ,
- Problem determination manual (348 pages) ,
- Troubleshooting and maintenance manual (189 pages)
Table of Contents
Advertisement
x4
Figure 110. Removing the screws of an expansion enclosure assembly
13. Turn the enclosure top side up and place it on a flat surface.
14. Remove the three screws and one screw-pin on the right side that secure the
15. Remove the three screws and one screw-pin on the left side that secure the
16. Remove the midplane assembly from the chassis by rotating the midplane
17. Unpack the replacement midplane assembly. Grasp the midplane assembly
18. Insert the tabs on the midplane assembly into the tab holes in the enclosure
19. Secure the midplane assembly to the chassis on both the right and left sides of
20. Turn the enclosure over so the bottom faces upwards and insert the four
21. Reinstall the enclosure in the rack cabinet, securing it with the two screws that
22. Reinstall the end caps at the front of the enclosure, as described in "Replacing
23. Reinstall the hard disk drives at the front of the enclosure. Ensure that each
24. Reinstall the canisters into the same slots they were removed from.
25. Reinstall the two power supplies.
26. Reconnect the data cables at the rear of the enclosure.
x4
x2
x2
midplane assembly to the enclosure (see Figure 110). Label the screws to
indicate the location from which they are removed and place them aside.
midplane assembly to the enclosure (see Figure 110). Label the screws to
indicate the location from which they are removed and place them aside. See
Figure 4.
assembly up about 45° and then lifting it out. Set the midplane assembly on a
flat surface.
with two hands and hold it at a 45° angle.
and rotate the front of the assembly down.
the enclosure by using the six screws and two screw-pins that you removed in
steps 14 and 15.
screws on the bottom of the enclosure that you removed in step 12 on page
360.
are removed at step 10 on page 360.
Storwize V7000 Gen2 enclosure end caps" on page 328.
drive is inserted back in the same slot from which it was removed.
Chapter 5. Control enclosure
361
Advertisement
Table of Contents
Troubleshooting
