IBM Storwize V7000 Unified Problem Determination Manual page 451

Table 120. Upgrade error codes and recommended actions (continued)
Error
Code Explanation
01C2 Failed while checking for current
running asynchronous jobs.
01C3 Could not stop CTDB.
01C4 Unable to remove callbacks
01C5 Could not reinstall Lib_Utils.
01C6 Failed while running
sonas_update_yum.
01C7 Unable to get list of cluster nodes.
01C8 Failed while running cnrsscconfig. Contact IBM Remote Technical Support.
01C9 Unable to install CIM
configuration.
01CA Unable to get name of cluster.
01CB Unable to install GPFS packages.
01CC Could not install platform. Upgrade
on target system.
01CD Unable to mount GPFS file systems. 1. See "Checking the GPFS file system
01CE Unable to update system security.
01CF Unable to configure node.
01D0 Unable to disable call home.
01D1 Unable to enable call home.
01D2 Failed to stop GPFS.
Action
1. Attempt to check status of lsrepl. If
this command is working restart
upgrade.
2. Contact IBM Remote Technical
Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
mount on each file module" on page
189
2. Restart upgrade and see if this was a
transient issue.
3. Follow GPFS troubleshooting
documentation.
4. Contact IBM Remote Technical
Support.
1. Restart upgrade and see if this was a
transient issue.
2. Contact IBM Remote Technical
Support.
1. Pull both power supply cables from
subject node. Wait 10 seconds, then
plug back in. After the system
restarts, try again.
2. Contact IBM Remote Technical
Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
1. Follow GPFS troubleshooting
documentation.
2. Contact IBM Remote Technical
Support.
Chapter 7. Recovery procedures
423