IBM Storwize V7000 Unified Problem Determination Manual page 157

Safety cover
1. Line up and insert the tabs on the bottom of the safety cover into the slots on
the system board.
2. Slide the safety cover toward the back of the file module until it is secure.
3. Connect the hard disk drive backplane power cables to the connector in front
of the safety cover.
4. Install the screw into the safety cover.
5. Install the file module cover (see "Installing the cover" on page 124).
6. Slide the file module into the rack.
7. Follow the steps at the end of the procedure "Removing a file module and
disconnecting power" on page 92 to reconnect the file module and resume its
use in the cluster.
Disk drive cable connections
Use the information described here to know about the cabling structure for the 8 x
2.5-inch hot-swap drive bays.
Screw
129
Chapter 4. File module