Removing The Hot-Swap Drive Backplane - IBM Storwize V7000 Unified Problem Determination Manual

SAS
signal
cable
Configuration
cable
Figure 70. Removing the hot-swap drive backplane
Procedure
1. Read the safety information that begins on page Safety and "Installation
2.
3. Slide the file module out of the rack.
4. Remove the cover. For more information, see Removing the cover.
5. Pull the hard disk drives or fillers out of the file module slightly to disengage
6. To obtain more working room, remove the fans.
7. Lift the backplane out of the file module by pulling it toward the rear of the
8. Disconnect the backplane power cable, SAS signal cable, and configuration
9. If you are instructed to return the backplane, follow all packaging instructions,
Installing the hot-swap drive backplane
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To install the replacement hot-swap drive backplane, complete the following steps.
Power
cable
guidelines" on page 94.
Follow the procedure in "Removing a file module and disconnecting power"
on page 92 to suspend the file module from the cluster and shut it down and
disconnect all power cords and external cables.
them from the backplane.
file module and then lifting it up.
cable.
and use any packaging materials for shipping that are supplied to you.
Hard disk drive
backplane
165
Chapter 4. File module