Unlocking The 3.5 Inch Drive - IBM Storwize V7000 Unified Problem Determination Manual
Hide thumbs
Also See for Storwize V7000 Unified:
- Introduction and implementation manual (670 pages) ,
- Problem determination manual (348 pages) ,
- Troubleshooting and maintenance manual (189 pages)
Table of Contents
Advertisement
About this task
Attention: If your drive is configured for use, go to the management GUI and
follow the fix procedures. Initiating the replacement actions without the assistance
of the fix procedures results in loss of data or loss of access to data.
Attention: Do not leave a drive slot empty. Do not remove a drive or drive
assembly before you have a replacement available.
The drives can be distinguished from the blank carriers by the color-coded striping
on the drive. The drives are marked with an orange striping. The blank carriers are
marked with a blue striping.
To replace the drive assembly or blank carrier, perform the following steps:
Procedure
1. Read the safety information to which "Preparing to remove and replace parts"
on page 295 refers.
2. Unlock the assembly by squeezing together the tabs on the side.
Figure 96. Unlocking the 3.5 inch drive
3. Open the handle to the full extension.
323
Chapter 5. Control enclosure
Advertisement
Table of Contents
Troubleshooting
