IBM Storwize V7000 Unified Problem Determination Manual page 208

Before you begin
Notes:
1. When you reassemble the components in the file module, be sure to route all
2. Connect a USB keyboard and VGA monitor to the file module before you
About this task
To reinstall the system board, complete the following steps.
Procedure
180
Storwize V7000 Unified: Problem Determination Guide 2073-720
cables carefully so that they are not exposed to excessive pressure.
power it back on in case it asks you to accept a system board configuration
change before it will boot up completely.
Pin
1. Align the system board at an angle, as shown in the illustration; then, rotate
and lower it flat and slide it back toward the rear of the file module. Make
sure that the rear connectors extend through the rear of the chassis.
Thumbscrew