IBM Storwize V7000 Unified Problem Determination Manual page 445

Table 119. Upgrade error codes from using the applysoftware command and recommended
actions (continued)
Error Code
EFSSG4101A
EFSSG4102
EFSSG4102A
EFSSG4103
EFSSG4103A
EFSSG4104
EFSSG4105
EFSSG4105C
EFSSG4106A
EFSSG4153
EFSSG4154
EFSSG4154A
The applysoftware
command explanation
The applysoftware command
returned required parameter
not specified.
The software package does
not exist.
The applysoftware command
returned software package
does not exist
The software package is not
valid.
The applysoftware command
returned invalid software
package return code.
An unexpected return code.
Unable to mount the USB
flash drive.
The applysoftware command
returned unable to mount
USB.
The applysoftware command
returned that there is
insufficient system file
system space.
The required parameter was
not specified.
You must start on primary
management node
mgmt001st001.
The applysoftware returned
must start on primary
management node
mgmt001st001.
Action
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
The package might be
corrupt. If this problem
persists, download a new
package and try again.
Call your next level of
support.
Run umount /media/usb, then
remove the USB flash drive.
Reinsert the USB flash drive.
If the error persists, remove
the USB flash drive and
reboot. After the system
reboots, reinsert the USB
flash drive.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
Switch to the other node and
try the command again.
Chapter 7. Recovery procedures
417