IBM Storwize V7000 Unified Problem Determination Manual page 174

3. Press down on the assembly. Make sure that the riser-card assembly is fully
4. Install the file module cover. For more information, see Installing the cover.
5. Slide the file module into the rack.
6. Reconnect the external cables; then, reconnect the power cords and turn on the
Removing a Fibre Channel PCI adapter
This removal instruction indicates the slot location for the Fibre Channel PCI
adapter.
About this task
The Fibre Channel adapter is in PCI slot 2.
Refer to "Removing a PCI adapter from a PCI riser-card assembly" on page 143 for
instructions.
Installing a Fibre Channel PCI adapter
This installation instruction indicates the slot location for the Fibre Channel PCI
adapter.
About this task
The Fibre Channel adapter must go in PCI slot 2.
Refer to "Installing a PCI adapter in a PCI riser-card assembly" on page 145 for
instructions.
Removing a 10-Gbps Ethernet adapter
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove the network adapter, complete the following steps:
Procedure
1. Read the Safety information and "Installation guidelines" on page 94.
2.
3. Remove the cover (see "Removing the cover" on page 123).
4. Loosen the thumbscrew on the rear of the chassis.
146
Storwize V7000 Unified: Problem Determination Guide 2073-720
seated in the riser-card connector on the system board.
peripheral devices and the file module.
Follow the procedure in "Removing a file module and disconnecting power"
on page 92 to suspend the file module from the cluster and shut it down, and
then disconnect all power cords and external cables.