Replacing Enclosure End Caps; Removing The 2.5 Inch Drive - IBM Storwize V7000 Unified Problem Determination Manual

Figure 101. Removing the 2.5 inch drive
4. Pull out the drive.
5. Push the new drive back into the slot until the handle starts to move.
6. Finish inserting the drive by closing the handle until the locking catch clicks

Replacing enclosure end caps

Remove and replace enclosure end caps.
Replacing Storwize V7000 Gen2 enclosure end caps
You can remove and replace enclosure end caps.
About this task
Attention: The left end cap is printed with information that helps identify the
enclosure.
v Machine type and model
v Enclosure serial number
The information on the end cap should always match the information that is
printed on the rear of the enclosure, and it should also match the information that
is stored on the enclosure midplane.
Procedure
To remove and replace either the left or right end cap, complete the following
steps.
1. If the enclosure is on a table or other flat surface, elevate the enclosure front
2. Grasp the end cap by the blue touch point and pull it until the bottom edge of
328
Storwize V7000 Unified: Problem Determination Guide 2073-720
into place.
slightly or carefully extend the front over the table edge.
the end cap is clear of the bottom tab on the chassis flange.