IBM Storwize V7000 Unified Problem Determination Manual page 190

6. Route the power cord through the clip next to power-supply and through any
7. Connect the power cord to a properly grounded electrical outlet.
8. Make sure that the error LED on the power supply is not lit, and that the ac
9. If you are replacing a power supply with one of a different wattage, apply the
Removing the operator information panel assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
162
Storwize V7000 Unified: Problem Determination Guide 2073-720
cable clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
power LED on the power supply are lit, indicating that the power supply is
operating correctly.
power information label provided with the new power supply over the existing
power information label on the server.
xxx-xxx/xxx-xxx
x,x/x,x
xx/xx Hz
Product certified in Shenzhen China
Made in China V
xxx-xxx/xxx-xxx
x,x/x,x
xx/xx Hz
Manufacturer IBM Corporation :
Copyright Code and Parts Contained Herein.
©Copyright IBM Corp 2010 All Rights Reserved .
/ - /
Canada ICES NMB 003 Class Classe A
Power cord
connectors
,
.
KCC REM IBC 7915
XXXX
xxx
- - -