Removing The Cover; Unit - IBM Storwize V7000 Unified Problem Determination Manual

Removing the cover

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove the cover, complete the following steps.
Figure 50. Removing the cover
Procedure
1. Read the safety information that begins on page Safety and "Installation
Table 53. Components identified as customer replaceable units (CRUs) and field
replaceable units (FRUs) (continued)
Types of Explanation of
replaceable each type of
parts replaceable part
Field replaceable FRUs must be
units (FRUs) installed only by
trained service
technicians.
3
2
1
Cover-release
latch
guidelines" on page 94.
Procedures categorized under each type of
replaceable part
"Installing the 240 VA safety cover" on page 128
"Removing a microprocessor and heat sink" on page
166
"Installing a microprocessor and heat sink" on page
170
"Removing and replacing the thermal grease" on
page 174
"Removing a heat-sink retention module" on page
176
"Installing a heat-sink retention module" on page
176
"Removing the system board" on page 177
"Installing the system board" on page 179
"Setting the machine serial number" on page 181
123
Chapter 4. File module