Removing/Replacing The Power Switch/Led Board Assembly; Power Switch/Led Board Assembly - IBM TS3310 Maintenance Information

Replacing the Operator Panel
To replace the Operator Panel, complete the removal procedure in reverse. For the
last step, perform "Returning a Library or Library Module to Normal Operations
after Repairs" on page 8-4.

Removing/Replacing the Power Switch/LED Board Assembly

The Power Switch/LED Board Assembly ( 1 in Figure 8-30) contains the power
ON/OFF button, power ON LED, and Operator Attention LED.
1
Figure 8-30. Power Switch/LED Board Assembly
Removing the Power Switch/LED Board Assembly
1. Perform "Preparing a Library or Library Module for Repairs" on page 8-4.
2. Perform "Removing the Access Door Bezel" on page 8-27.
3. Disconnect the small white connector ( 2 in Figure 8-30).
4. Remove the two screws ( 3 in Figure 8-30).
5. Remove the Power Switch/LED Board Assembly from the Control Module.
Replacing the Power Switch/LED Board Assembly
1. Perform "Removing the Power Switch/LED Board Assembly" in reverse order.
2. Perform "Returning a Library or Library Module to Normal Operations after
8-32
TS3310 Tape Library Maintenance Information
3
Note that the FRU kit for this assembly contains the cable and cable ties. If you
suspect the cable may be failing, replace it also.
Repairs" on page 8-4.
2