IBM Storwize V7000 Unified Problem Determination Manual page 240

-noimm
panel_name
Description
This command moves a snap file to a USB flash drive.
This command calls the satask snap command.
If collected, the IMM FFDC file is present in the snap archive in
/dumps/imm.ffdc.<node.dumpname>.<date>.<time>.tgz. The system waits for up to
five minutes for the IMM to generate its FFDC. The status of the IMM FFDC is
located in the snap archive in /dumps/imm.ffdc.log. These two files are not left on
the node.
An invocation example
satask snap -dump 111584
The resulting output:
No feedback
Install software command:
Use this command to install a specific update package on the node canister.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
►►
Parameters
-file filename
-ignore | -pacedccu
Description
This command copies the file from the USB flash drive to the update directory on
the node canister and then installs the update package.
This command calls the satask installsoftware command.
212
Storwize V7000 Unified: Problem Determination Guide 2073-720
(Optional) Indicates the /dumps/imm.ffdc file should not be included in the
output.
(Optional) Indicates the node on which to execute the snap command.
satask installsoftware
(Required) The filename designates the name of the update package .
(Optional) Overrides prerequisite checking and forces installation of the update
package.
-file filename ►◄
-ignore
-pacedccu