Installing The Fan Bracket - IBM Storwize V7000 Unified Problem Determination Manual

Pins
Figure 62. Installing the fan bracket
Procedure
1. Lower the fan bracket into the chassis.
2. Align the holes in the bottom of the bracket with the pins in the bottom of the
3. Press the bracket into position until the fan-bracket release levers click into
4. Replace the fans.
5. Replace the PCI riser-card assemblies. For more information, see Installing a
6. Install the cover. For more information, see Installing the cover.
7. Slide the file module into the rack.
8.
Removing a PCI riser-card assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
Fan-bracket
release latches
chassis.
place.
PCI riser-card assembly.
Follow the steps at the end of the procedure in "Removing a file module and
disconnecting power" on page 92 to suspend the file module to reconnect the
file module and resume its use in the cluster.
141
Chapter 4. File module