Power Synchronization - EFI E-43A Installation And Service Manual

U
SING THE
3 From the Home screen of the copier/printer touch panel, select Fiery. If the Fiery icon does
not display, press the button (
icon view.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
N : Notify the network administrator before you remove the E-43A from the network.
OTE
4 Press the Fiery tab.
5 Press Restart Fiery.
6 At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)— Resets the E-43A server software but does not reboot
the entire system. Network access to the E-43A is temporarily interrupted and all currently
processing jobs are aborted and may be lost. If you choose this option, you may need to
wait 1 minute or more for the server software to reset.
• Reboot System (hard reset)— Shuts down all E-43A activity properly and then reboots.
Network access to the E-43A is temporarily interrupted and all currently processing jobs
are aborted and may be lost.
• Shut Down— Shuts down all E-43A server software and powers off the system. You should
always select this option when you want to power off the system. Network access to the
E-43A is terminated and all currently processing jobs are aborted and may be lost.
Use the reset button on the front of the E-43A only if the system is unresponsive to
N :
OTE
keyboard or mouse actions.
7 Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-43A.

Power synchronization

You can enable the power synchronization feature by using the switch on the printer interface
board. The default switch position is OFF.
When you enable power synchronization, the E-43A synchronizes power with the copier/
printer's main power off/on status. If the copier/printer powers off, the E-43A receives signals
from the copier/printer through the USB cable connected to the printer interface board, and
automatically starts the shutdown process. If the E-43A receives the startup signals from the
copier/printer, the E-43A automatically powers on and begins the startup sequence.
The USB cable may not be provided in some regions or countries. If the customer site
N :
OTE
requires the power synchronization and the USB cable was not provided with the copier/
printer, contact your authorized support/service center.
After the power synchronization is enabled, make sure to control the E-43A power using the
copier/printer.
E-43A
)on the upper right corner of the screen to switch to the
35