Jumpers; Figure 26: Motherboard Battery - EFI E-43A Installation And Service Manual

R
EPLACING PARTS
T
O REPLACE THE BATTERY
1 Shut down, and then open the E-43A (see pages
2 Locate the battery on the motherboard (see
3 Carefully push the clip away from the battery until the socket ejects the battery.
F 26: Motherboard battery
IGURE
4 Slide the battery out of its socket.
5 Wait two minutes to allow the motherboard electrical components to fully discharge.
6 To insert a new battery, slide it into the socket so that the positive (+) side of the battery
faces front.
7 Press the battery down into the socket until it snaps into place.
Make sure that the battery is securely installed in the socket.
8 Reassemble the system and verify its functionality (see
9 Configure the time and date in Setup (see Configure Help for more information).
Failure to configure the time and date will cause the E-43A to hang when user software is
being installed on the E-43A. (See

Jumpers

Jumper configurations should not be changed.
Jumper
J4
Pin 1
Clip
Battery
Socket
page 110.)
Description
J4 is the Clear CMOS and Password jumper.
Default configuration: jumper cap installed on pins 2 and 3.
It is not necessary to clear the CMOS settings when servicing
N :
OTE
motherboard components, the DVD drive, and the hard disk drive.
43 and 44).
Figure on page 57).
page 86).
71