Normal Startup Sequence; Figure 35: Normal Startup Sequence - EFI E-43A Installation And Service Manual

Verifying the system
T 1:
ABLE
Conditions to verify
Each cable required is:
• Present
• The correct type
• Installed in the correct connector
• Well-seated
• Not visibly damaged (including connectors)
If included in the system, the required mouse, monitor, and keyboard
are present and appear undamaged. The mouse and keyboard are
connected to the correct ports on the E-43A connector panel.
The cables required are:
• Present
• Installed in the correct connector
• Well-seated
• Not visibly damaged (including connectors)
Code in motherboard BIOS
1
initializes and configures
areas on the motherboard.
Power on
Activity light
blinks orange
3 seconds
T
ROUBLESHOOTING

Normal startup sequence

N : The following description is approximate. The screens, times, and sequences that you
OTE
observe may vary slightly.
Activity light
blinks orange
S T A R T I N G U P. . .
45 seconds
Normal startup sequence
F 35:
IGURE
Part and additional page references
UIB cable, page 50
Hard disk drive data cable,
Printer interface cable(s),
DVD drive power and data combination cable,
Power cable(s), page 73
• Mouse (if applicable)
• Monitor (if applicable)
• Keyboard (if applicable)
• Monitor power cord (not pictured)
Windows operating system
2
establishes communication
with E-43A devices.
Activity light
blinks green
S T A R T I N G U P. . .
2 minutes, 30 seconds
103
page 75
page 49
page 84
System software on the hard
3
disk drive completes startup
process. The E-43A is at
Idle.
Activity light
is off
Server name Server name