Completing Installation And Starting Up - EFI E-43A Installation And Service Manual

I
NSTALLING

Completing installation and starting up

To finish the installation of the E-43A at the customer site, make sure to do the following:
1 Make sure that the copier/printer is powered on.
If the power synchronization is set to ON, the E-43A will start automatically. Proceed with
step 3.
2 Power on the E-43A (see
Make sure that the power cord is attached and that the power switch on the connector panel is
in the ON position(|). Press the power button
button. The power supply automatically senses the correct voltage.
3 Wait for the system to power on and for the E-43A Info screen to reach Idle.
N : If the message "Check power and cable" displays on the copier/printer copier/printer
OTE
touch panel, verify that the copier/printer interface cable is connected correctly to the copier/
printer and the E-43A.
4 Perform any required system software upgrades.
For instructions, see the documentation that accompanies the E-43A service upgrade.
Updates to Fiery Server Software may be available for the E-43A from a variety of sources (for
example, System Updates (see
the customer).
Windows operating system updates should be obtained from Microsoft directly. Because such
updates are available directly from Microsoft, EFI does not maintain or provide them via the
System Updates feature.
5 Print a Test Page and a Configuration page and ask the customer to verify the output.
6 If the E-43A requires a static IP address (for example, in a non-DHCP network environment),
work with the network administrator to configure it as described on
7 Change the factory default language, if needed.
For more information on changing the factory default language, see
8 Ask the network administrator to perform Setup and to print some test documents over
the network.
9 Store the output and the current Configuration page(s) near the copier/printer.
10 Inform the site administrator that the E-43A user software must be installed on networked
computers that print to the E-43A.
11 Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the
E-43A is stored in a safe location, accessible to you.
H
ARDWARE
page 32).
page 95), patches provided on CD, or patches downloaded by
on the front panel once and release the
( )
page
page
24
23.
92.