EFI E-43A Installation And Service Manual page 33

U E-43A
SING THE
T E-43A
O START THE
1 Make sure that the power cable is attached and that the power switch is in the ON
position (|).
2 Press the power button (
3 Check the Activity light on the control panel.
The power supply automatically senses the correct voltage. Allow startup to proceed without
interruption. Do not press any buttons on the control panel while the system is starting.
T , ,
O SHUT DOWN RESTART OR REBOOT FROM THE
Notify the network administrator before you remove the E-43A from the network.
N :
OTE
1 Make sure that the E-43A is not receiving, processing, or printing any jobs.
If Printing appears on the control panel, the E-43A is processing. You must wait until the
system finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
)on the front panel.
E-43A
CONTROL PANEL
33