Removing And Replacing Boards - EFI E-43A Installation And Service Manual

R
EPLACING PARTS
5 To replace the top panel, route the UIB cable through the hole in the top of the chassis and
attach it to motherboard connector J27.
6 Position the top panel on the top of the chassis.
Place the hooks on the underside of the panel into the slots in the top of the chassis, and then
slide the top panel toward the back of the chassis to engage the hooks.
N : You may need to tap the front edge of the panel toward the back of the chassis to
OTE
engage the panel completely.
7 Replace the plug on the top panel.
Correctly align the plug, and then place it into the receptacle on the top panel. Secure the
plug by replacing the locking bolt through the cutout in the left side of the top panel.
The locking bolt requires a 3/16 Allen wrench.
N :
OTE

Removing and replacing boards

This section includes procedures for removing and replacing the following boards:
• Printer interface board
• User interface board
• Motherboard
The E-43A is shipped from the factory with a standard board configuration. If optional
components have been installed, see the documentation that accompanies the particular
option kit.
48