Perkins 900 Series Workshop Manual page 92

5
900 Series
To remove Operation 5-5
The thrust washers fit in recesses machined on each side of the rear main bearing cap. Ensure that the correct
size thrust washers are fitted.
1 Drain the lubricating oil and remove the lubricating oil sump, see Operation 10-4 or Operation 10-6.
2 Remove the flywheel, see Operation 13-1
3 Remove the flywheel housing, see Operation 13-3
4 Remove the rear oil seal housing, see Operation 5-2.
5 Release the two setscrews that retain the rear main bearing cap. Remove the setscrews and carefully
remove the bearing cap. Do not damage the cork seal on the bearing cap.
6 Remove the two bottom thrust washers (A1) from the rear main bearing cap.
7 The two top thrust washers (B1) can be removed by the use of a suitable piece of plastic (B2) to push them
out.
1
1
2
A B
C0058 C0062
82 Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale