Perkins 900 Series Workshop Manual page 50

3
900 Series
9 Fit the push rods (G1) correctly in the sockets of the tappets. Set the adjustment screw in the rocker lever
to just contact the socket in the push rod.
10 Set the valve tip clearances, see Operation 3-6.
11 Lubricate thoroughly the rocker shaft assembly, the valves and the push rods with clean engine lubricating
oil.
Note: It is possible that after assembly, the rocker shaft springs may be in contact with the cylinder head
fasteners (H1). This is acceptable, only if the side to side movement of the spring is not restricted and is free
to operate normally.
1
1
G
H
C0027
C0025/1
40 Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale