Perkins 900 Series Workshop Manual page 161

900 Series
8 Fit a new cork seal (D3) into the groove in the cap of the rear main bearing . Ensure that the edge of the
cork seal is in contact with the left-hand sump joint and press the seal into the groove gradually and evenly
with a suitable tool (D1) until the seal is fitted fully into the groove and contacts the right-hand joint.
1
2
3
D
9 Apply a 3 mm bead of POWERPART Silicone sealing and jointing compound on the surface of the sump
joints from the cork seals to the edge of the cylinder block as shown (E).
10 If a blue rubber seal is used, ensure that a 3 mm bead of silicon sealant (F2) is applied to the surface of
the joint (F1). The sealant must not extend further than 15 mm up the side of the blue rubber seal (F3).
2
1
F
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale
3
C1053-1
E
C0099
10
C0128B
Continued
151