14
900 Series
To adjust the drive belt tension
Operation 14-2
1 Loosen the pivot fasteners (A2) of the alternator and the fasteners of the adjustment link (A1).
2 Change the position of the alternator to give the correct tension. Tighten the adjustment link fasteners and
then the pivot link fasteners.
3 Check the belt tension again to ensure that it is still correct.
Note: If a new belt is fitted, the belt tension must be checked again after the first 25 hours of operation.
1
2
A
C0009
Workshop Manual, TPD 1345E, issue 3
213
This document has been printed from SPI². Not for Resale