4
900 Series
To dismantle
Operation 4-8
1 Remove the piston rings, see Operation 4-10.
2 Remove the circlips that retain the gudgeon pin.
3 Put a mark on the piston to indicate the cylinder number as shown on the connecting rod. Put the mark on
the piston on the same side as the mark on the big end to ensure that they are assembled correctly (A).
4 Push the gudgeon pin out by hand. If the gudgeon pin is tight, heat the piston to 40/50 °C (100/120 °F) for
easy removal of the gudgeon pin.
3
1
2
A
C0046
Workshop Manual, TPD 1345E, issue 3
71
This document has been printed from SPI². Not for Resale