Perkins 900 Series Workshop Manual page 157

10
900 Series
13 Tighten all the fasteners to 22 Nm (16 lbf ft) 2,2 kgf m. Fit the drain plug (H1) together with a new rubber
"O" ring and tighten the plug to 34 Nm (25 lbf ft) 3,5 kgf m. Where necessary, fit the dipstick tube and the
dipstick.
Cautions:
l Do not fill the sump past the mark (H2) on the dipstick or damage could occur to the engine
l If the lubrication system has been drained, ensure that the rocker gear and camshaft reservoir are
lubricated before starting the engine.
14 If the engine has a filler in the rocker cover, enough time should be allowed for the oil to cover the rocker
gear and fill the camshaft reservoir before the level is checked on the dipstick. Fill the sump to the mark (H2)
on the dipstick with an approved lubricating oil.
15 If the engine has a filler on the timing case; remove the rocker cover and pour one litre of an approved
lubricating oil over the rocker gear and allow to drain into the camshaft reservoir and sump. Fit the rocker cover
and fill the sump to the mark (H2) on the dipstick through the filler on the timing case.
16 Start the engine and check for leakage. Stop the engine. After 15 minutes check the oil level on the dipstick
and, if necessary put more lubricating oil into the sump.
2
1
H
C0014C
Workshop Manual, TPD 1345E, issue 3 147
This document has been printed from SPI². Not for Resale