Perkins 900 Series Workshop Manual page 94

5
900 Series
7 Lightly lubricate the setscrew threads with clean engine lubricating oil. Fit the setscrews and tighten them
gradually and evenly to 152 Nm (112 lbf ft) 15,5 kgf m. Check the crankshaft end-float, see Operation 5-4.
8 Apply POWERPART Silicone sealing and jointing compound to each end of the cork seals at the bridge
piece and the rear bearing housing (C).
9 Fit the rear oil seal housing, see Operation 5-2.
10 Fit the flywheel housing, see Operation 13-3
11 Fit the flywheel, see Operation 13-1
12 Fit the sump, see Operation 10-5 or Operation 10-7.
13 Fill the sump to the correct level with an approved lubricating oil.
C
C0098
84 Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale