Perkins 900 Series Workshop Manual page 220

13
900 Series
Flywheel housing
To remove and to fit Operation 13-3
Warning! The flywheel housing is heavy, use lift equipment or get assistance with the lift operation before
removal of the flywheel housing fasteners.
To remove
1 Remove the starter motor, see Operation 14-6, and the flywheel, see Operation 13-1.
2 Release the six setscrews and the two Allen screws. Carefully hit the housing, with a soft face hammer, to
remove it from the dowels.
To fit
1 Ensure that the rear face of the cylinder block and the faces of the housing are clean and free from damage.
Ensure that the location dowels are fitted correctly.
2 Fit the housing onto the dowels and tighten the setscrews and the two Allen screws to 44 Nm (32 lbf ft)
4,5 kgf m.
3 Fit the flywheel, see Operation 13-1, and the starter motor, see Operation 14-6.
210 Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale