Perkins 900 Series Workshop Manual page 107

6
900 Series
6 Check that the idler gear has end-float (C) of 0,13/0,38 mm (0.005/0.015 in) on the hub. The maximum
permissible end-float is 0,46 mm (0.018 in).
7 If a new gear is fitted, check that there is a minimum backlash (D) of 0,08 mm (0.003 in).
8 Lubricate the teeth of the gears with clean engine lubricating oil.
9 Fit the timing case cover, see Operation 6-2.
C D
C0105 C0106
Workshop Manual, TPD 1345E, issue 3 97
This document has been printed from SPI². Not for Resale