12
900 Series
Fan
To remove and to fit
Operation 12-8
To remove
Release the four setscrews and remove the fan. If necessary, fit the setscrews to retain the fan extension and
the pulley to the hub.
To fit
Clean thoroughly the rear of the fan where it fits onto the fan extension. Also ensure that all paint is removed
from this area. Put the pulley into position on the hub and the fan extension onto the pulley. Clean the front
face of the fan extension. Fit the fan and tighten the setscrews to 22 Nm (16 lbf ft) 2,2 kgf m.
206
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale