Perkins 900 Series Workshop Manual page 211

900 Series
To fit
Special requirements
Description
POWERPART Thread lock (pipe)
1 If the adaptor plate (A5) has been removed, thoroughly clean the joint faces of the adaptor plate (A5) and
the coolant pump body (A6). Apply a narrow bead of POWERPART jointing compound to the joint face of the
coolant pump. Fit a new joint between the adaptor plate and the coolant pump body. Fit the adaptor plate.
Remove the excess jointing compound.
2 Fit the nut and bolt (A1) and tighten the nut to 44 Nm (33 lbf ft) 4,5 kgf m. Tighten the Allen screw (A3).
3 Thoroughly clean the mounting faces of the timing case and the rear of the adaptor plate.
4 Apply POWERPART Thread lock (pipe) to the first three threads of the four setscrews (A4). Put them into
their positions in the pump body and the adaptor plate.
5 Fit the coolant pump to the timing case and tighten the five setscrews to 44 Nm (33 lbf ft) 4,5 kgf m.
6 Put the pulley onto the hub of the pump shaft and tighten the four M8 setscrews to 22 Nm (16 lbf ft) 2,2 kgf m
to secure the pulley to the hub.
7 Connect the hoses to the coolant pump and tighten the clips.
8 Fit the fan belt, see Operation 14-3.
9 Fit the fan, see Operation 12-8.
1
A
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale
Consumable products
Part number
27610033
2
3
4
5
6
Description
POWERPART Jointing compound
C0090
12
Operation 12-5
Part number
27610122
201