Perkins 900 Series Workshop Manual page 215

12
900 Series
5 Support the pulley end of the shaft and press the new impeller (C6) onto the shaft until the back of the
impeller is exactly level with the rear of the coolant pump body. This will ensure that the clearance between
the impeller blades and the pump body is correct. Rotate the shaft to ensure that the impeller is free.
6 Apply a narrow ring of POWERPART Retainer (oil tolerant) to the pump shaft. Support the impeller end of
the shaft and press the hub onto the shaft until the end of the shaft is level with the front face of the hub.
Remove the excess retainer.
7 Fit the coolant pump to the engine, see Operation 12-5.
5
4
3
2
1
6
C
C0092/A
Workshop Manual, TPD 1345E, issue 3 205
This document has been printed from SPI². Not for Resale