6
900 Series
Note: Some engines have a different arrangement to retain the fuel pump gear. If the gear is retained by one
torx screw (C1) and three Allen screws (C2) then tighten the fasteners to 27 Nm (20 lbf ft) 2,7 kgf m. A special
tool to remove and fit the Torx screw is available at your Perkins distributor.
6 If a new gear has been fitted, use a feeler gauge to check the backlash.
7 Fit the timing case cover, see Operation 6-2.
8 Fill the cooling system, Operation 12-3.
2
1
C
C1000
102
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale