Samson TROVIS 5573 Mounting And Operating Instructions page 81

The time stamp [Date], [Time] is added by the text messaging center, not by the controller. If an
error message is transmitted via the device bus to a controller equipped with a dial-up modem,
the controller ID of the faulty controller is sent, instead the controller ID of the "modem control-
ler". A detailed error message is not available.
Note: The controller ID is indicated in the extended information level under Info 2 listed as the
first value in the sequence (-> section 1.8).
When Modbus is activated and, at the same time, the dial-up in case of error is released, the
connection with the building control station is established first, and then the text message is sent.
If the first attempt to connect to the building control station fails, the controller tries again until
the programmed number of redialing attempts has been exhausted.
In Germany, the access numbers (TAPnr) of the SMS service center are currently:
4
D1 network: 0171 252 1002 (alternatively, 0171 252 1099 is also possible)
4
E-Plus network: 0177 1167
4
Cellnet (UK) network: 0044 786 098 0480 – routing into the D1, D2 and E-Plus networks.
Add "0" to the number when dialing from a telephone extension. The mobile phone number
(HAndi) must be entered as follows: 49 xxx yyyyyy, where xxx stands for 160, 171 or any other
valid dialing code and yyyyyy represents the specific phone number of the mobile you wish the
error message to be sent to.
Functions
Text message
Modem function
Automatic modem configuration
Parameters*
Modem dialing pause (P)
Modem timeout (T)
No. of redialing attempts (C)
Access number (TAPnr)
Mobile phone number (HAndi)
* –> section 9.3 (Description of communication parameter settings)
WE Configuration
0 CO6 -> F08 - 1
0 CO6 -> F03 - 1
0 CO6 -> F04 - 1
WE Parameter level / Range of values
5 min PA6 / 0 to 255 min
5 min PA6 / 1 to 255 min
15 PA6 / 1 to 255
– PA6 / Max. 22 characters; 1, 2, 3, ..., 9, 0;
"-" end of a string; "P" pause
– PA6 / Max. 22 characters; 1, 2, 3, ..., 9, 0;
"-" end of a string; "P" pause
Operational faults
81
EB 5573 EN