Operating Modes; Setting The Operating Modes - Samson TROVIS 5573 Mounting And Operating Instructions

1.2

Operating modes

Day mode (rated operation)
mode, the set points relevant for rated operation are used by the controller.
Night mode (reduced operation)
relevant for reduced operation are used by the controller.
: Regardless of the programmed times-of-use, control operation is deacti-
Stand-by mode
vated. Only the frost protection is activated, if need be.
Automatic mode
tion. Outside these times-of-use, the controller is in reduced operation, unless control operation
is deactivated depending on the outdoor temperature. The controller switches automatically be-
tween both operating modes.
: Valves and pumps can be controlled manually (–> section 3).
Manual mode

1.2.1 Setting the operating modes

1. Turn the rotary switch to
4
For systems with just one control circuit (e.g. Anl 1.0), steps 2 and 3 can be skipped
(selecting the control circuit).
2. Select the control circuit whose operating mode is to be set [q]:
Heating circuit 1
Heating circuit 2
DHW circuit/circulation pump (DHW)
4
Only those control circuits are available for selection which can be controlled by the
system schematics (Anl) selected.
3. Confirm the control circuit [ ].
4. Select the operating mode [q]:
5. Confirm the operating mode [ ].
6. Return the rotary switch to normal switch position
Note: In automatic mode, the momentary stage of the operating schedule (
for night mode) is displayed in the information level together with the icon
: Regardless of the programmed times-of-use and summer
: Regardless of the programmed times-of-use, the set points
: During the programmed times-of-use, the controller works in rated opera-
(operating modes). blinks on the display.
, , or
(information level).
Operation
for day mode or
.
7
EB 5573 EN