Translation Tbl; Column 132 Wrap - Printronix P5005B User Manual

Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
Chapter 4
Coax/Twinax Emulation
Intervention Req
•
Send to Host. The printer sends a signal to the host computer
when the CANCEL key is pressed or a printer fault or hold
mode time-out occurs.
•
Do Not Send. No signal will be sent to the host computer.
Buffer Print
•
Disable. The printer will print normally.
•
Enable. The printer prints the EBCDIC data and control codes
received from the host as hex values. Refer to page 189 for
information on how to obtain a hex code printout.

Translation Tbl

Prints out a table of the coax interface's current character set. This
operation is valid only when the coax interface is selected (see
"HOST INTERFACE" on page 195).

Column 132 Wrap

When enabled, this option causes the printer to line wrap at 132
characters despite the current print density allowing more
characters per line.
PA1
PA1 is only valid when the printer is in the OFFLINE state and the
coax Systems Network Architecture Character String (SCS) data
stream is active. This function displays the "PA1 ENABLED"
message when the ENTER key is pressed and sends a special
operator request to the host when the printer is placed ONLINE.
Refer to the Coax/Twinax Programmer's Reference Manual for
more information about SCS.
142