Table of Contents
Advertisement
Chapter
4
Coax/Twinax (CTHI) Emulation
Compatibility
Op
(from page 106)
CR At
MPP+1
MPP+1
On*
On*
Off
Off
Auto Skip
FF After Job
At End
Off*
Off*
On
On
Char Set Select
Specifies the print language used by the printer. Character sets are shown in
detail in the Character Sets Reference Manual .
Translation Tbl
Prints out SCS and DSC/DSE tables of the Coax interface's current character
set. This operation is valid only when the Coax interface is selected as the
current interface (see "HOST INTERFACE" on page 72).
Active Char Set
Selects which group of character sets (Primary or Secondary) will be active.
Secondary Set is the default.
Prt Partial Line
•
Enable (default). Forces the printer to print if a partial line is in the printer
(i.e., line not ending with a LF).
•
Disable. The last partial line of data will not be printed.
PA1
PA1 is only valid when the printer is in the offline state and the coax Systems
Network Architecture Character String (SCS) data stream is active. This
function displays the "PA1 ENABLED" message when the ENTER key is
pressed and sends a special operator request to the host when the printer is
put back in Online mode. Refer to the Coax/Twinax Programmer's Reference
Manual for more information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED" appears on the
108
NL At
Position Aft FF
Last Char = FF
(4234 only)
Off*
On*
On
Off
CR, EM & NL
(3287 only)
On*
Off
operator panel) or selecting the PA2 menu item will reset the pending
PA1 function.
* = Factory Default
Null
FF Validity
Suppression
Off*
Off*
On
On
Advertisement
Table of Contents
