Bc Check Digit; Barcode Darkmode; Pum Default; Truncate Pi Slew - Printronix P5005B User Manual

Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
Chapter 4
ANSI Emulation
Pos. on BC/OvrSz
•
Set to top. The paper is fed back to the top of barcodes or
oversized characters after they are printed. This allows printing
on the same line.
•
Set to bottom. The printer will continue printing without
backing up.

BC Check Digit

•
By host. The host calculates the barcode check digit and
sends it along with the barcode. The check digit is not verified
by the printer, but printed as it was received.
•
By printer. The barcode is sent without the check digit, and the
printer calculates and adds it in.

Barcode Darkmode

•
Enable. The barcodes are printed at a higher resolution.
•
Disable. The barcodes are printed at lower resolution but at a
higher speed.

PUM Default

This is the Unit Of Measure (UOM) as it is used within the ANSI
emulation. Coordinates received in ESC sequences can be sent in
two UOM's: Decipoints, which is a unit of 1/720 inch, or in lines or
columns using the current LPI and CPI values. The UOM used is
determined by this configuration setting.

Truncate PI Slew

•
Truncate At TOF. The slew is terminated when the next Top-of-
Form is reached. (This function applies to the ANSI EVFU
only.)
•
Disable. PI slews will be completed independent of their
length.
182