Printronix P5005B User Manual page 35

Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
1. Make sure the printer power switch is set to O (Off).
2. Open the cabinet rear door, and remove the cover from the
selected I/O connector. (See Figure 4.)
3. Locate the cable routing notch in the lower left corner of the
back of the cabinet (see Figure 4).
4. Hold the I/O cable below its connector and gently push the
cable through the opening in the grommet seated in the notch.
5. Pull the cable up through the notch until it reaches the I/O plate.
Attach the cable connector to the printer interface connector
previously selected in step 2 of this section. Secure the cable to
the printer using the upper and lower standoffs.
6. Open the cabinet front door and cut the strap that secures the
box, which contains the power cord, printer ribbon, control
panel overlay labels, and documentation.
7. Open the box and remove the power cord, overlays, and
documentation.
Cabinet Model
35