Toyota Tundra 2005 Service - Repair - Maintenance page 3172

BO-58
Protector
A - A
A - A
Protector
A
A
Protector
H20782
A
Protector
A
H20781
BODY - WHEEL OPENING MOULDING
INSTALLATION
1. INSTALL QUARTER OUTSIDE MOULDING
(a) Clean the body mounting surface.
(1) Using a heat light, heat the body mounting surface
to 40 to 60°C (104 to 140°F).
(2) Remove the protector from the body.
(3) Wipe off the stains with cleaner.
(4) Install a new protector as shown in the illustration.
(b) Install the quarter outside moulding.
(1) Using a heat light, heat the body and moulding.
Body: 40 to 60°C (104 to 140°F)
Moulding: 20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the body and moulding excessively.
(2) Remove the moulding release sheet from the face
of the moulding.
NOTICE:
When removing the moulding release sheet, be careful that
dirt or dust will not adhere to the face of the moulding.
(3) Align the bosses with their corresponding holes on
the body and press the moulding firmly.
NOTICE:
Do not apply excessive force onto the moulding, but steady
pressure with your thumbs.
(4) Install the 6 screws.
2. w/ Rear mudguard:
INSTALL REAR MUDGUARD
Install the rear mudguard with the 4 screws.
3. INSTALL FRONT FENDER OUTSIDE MOULDING
(a) Clean the body mounting surface.
(1) Using a heat light, heat the body mounting surface
to 40 to 60°C (104 to 140°F).
(2) Remove the protector from the body.
(3) Wipe off the stains with cleaner.
(4) Install a new protector as shown in the illustration.
(b) Install the front fender outside moulding.
(1) Using a heat light, heat the body and moulding.
Body: 40 to 60°C (104 to 140°F)
Moulding: 20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the body and moulding excessively.
Author :
BO4H4-03
Date :
4829