Toyota Tundra 2005 Service - Repair - Maintenance page 3360

Hide thumbs Also See for Tundra 2005:

Table of Contents

Check the functioning of SST.

When activating the seat belt pretensioner, always use the

specified SST (SRS Airbag Deployment Tool.)

Do not connect the yellow connector which will be connected

with the seat belt pretensioner.

If the LED lights up when the activation switch is not being

pressed, SST may be malfunctioning. Definitely do not use

Disconnect the negative (-) terminal cable from the bat-

Work must be started at least 90 seconds after the ignition

switch is turned to the LOCK position and the negative (-)

terminal cable is disconnected from the battery.

(The SRS is equipped with a back-up power source. If work

is started within 90 seconds of disconnecting the negative

(-) terminal cable from the battery, the SRS may deploy.)

Standard cab:

Disconnect the pretensioner connector.

SEAT BELT PRETENSIONER

09082-00700, 09082-00740

Connect the SST to the battery.

Connect the red clip of the SST to the battery posi-

tive (+) terminal and the black clip to the battery neg-

ative (-) terminal.

Check the functioning of the SST.

Press the SST activation switch, and check that the

LED of the SST activation switch lights up.

Disconnect the SST from the battery.

Remove the front door scuff plate.

Remove the front pillar garnish.

Remove the back panel upper garnish.

Remove the front seat outer belt floor anchor.

Remove the quarter trim.

Disconnect the pretensioner connector as shown in

the illustration.