Configure The Process Variables Shown On The Display - Emerson Micro Motion 2700 Configuration And Use Manual

Configure device options and preferences
The languages available depend on your transmitter model and version.
5.1.2

Configure the process variables shown on the display

Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Variables
Overview
You can control the process variables shown on the display and the order in which they
appear. The display can scroll through up to 15 process variables in any order you choose.
In addition, you can repeat variables or leave slots unassigned.
Restrictions
•
•
Note
If you configure a display variable as a volume process variable and then change Volume Flow Type, the
display variable is automatically changed to the equivalent process variable. For example, Volume Flow
Rate would be changed to Gas Standard Volume Flow Rate.
Procedure
For each display variable you want to change, assign the process variable you want to use.
Example: Default display variable configuration
Display variable
Display Variable 1
Display Variable 2
Display Variable 3
Display Variable 4
Display Variable 5
Display Variable 6
Display Variable 7
Display Variable 8
Display Variable 9
78
Not available
ProLink > Configuration > Display
Device Tools > Configuration > Transmitter Display > Display Variables
You cannot set Display Variable 1 to None. Display Variable 1 must be set to a process variable.
If you have configured Display Variable 1 to track the primary mA output, you cannot change
the setting of Display Variable 1 using this procedure. To change the setting of Display Variable 1,
you must change the configuration of mA Output Process Variable for the primary mA output.
Process variable assignment
Mass flow
Mass total
Volume flow
Volume total
Density
Temperature
External pressure
Mass flow
None
®
Micro Motion Model 2700 Transmitters with Analog Outputs