Lldp Admin-Status; Lldp Frame-Format - Planet Networking & Communication GS-2240-48T4X Command Manual

Switch# configure terminal
Switch (config)# interface ge4
Switch (config-ge4) # line-rate egress 120m

4.3.5.16 lldp admin-status

Command:
lldp admin-status { disable | rx | tx | txrx }
disable The port can neither transmit nor receive LLDP frames
rx The port can only receive LLDP frames
tx The port can only transmit LLDP frames
txrx The port can both transmit and receive LLDP frames
Default:
Disable
Usage Guide:
To configure LLDP Rx only mode for specific interface
Example:
To configure LLDP Rx only mode for ge4
Switch# configure terminal
Switch (config)# interface ge4
Switch (config-ge4) # lldp admin-status rx

4.3.5.17 lldp frame-format

Command:
lldp frame-format {direct | snap}
direct Direct-encoded LLDP frame format
snap SNAP-encoded LLDP frame format.
Default:
Enabled
Usage Guide:
To configure frame-format of LLDP TLV for specific interface
Example:
To configure frame-format(SNAP mode) of LLDP TLV for ge4
-30-
Command Guide