Acura NSX 1997 Service Manual page 69

Table of Contents

Adjust the timing belt (see page 6-14).

Install the lower cover and middle covers.

Install the crankshaft pulley, then tighten the pulley

bolt (see page 6-12).

Check the crankshaft pulley and the camshaft pul-

leys at TDC.

NOTE: To check the camshaft, try to insert 5.0 mm

pin punches as shown when the camshaft is at TDC.

MIDDLE COVER

Table of Contents

(White paint)

MIDDLE COVER

10. If a camshaft is not positioned at TDC, remove the

timing belt and adjust the positioning following the

procedure on page 6-18, then reinstall the timing

11. After installation, adjust the tension of each belt.

for alternator belt tension adjust-

for A/C compressor belt tension

Chapters

Table of Contents