Acura NSX 1997 Service Manual page 526

Table of Contents

Install the spring and cap, then fit the outboard joint

onto the driveshaft.

CAUTION: Reinstall the outboard joint in the origi-

nal position on the rollers.

OUTBOARD JOINT

Fit the circlip into the outboard joint inner groove.

Table of Contents

Align the roller holders with the

outboard joint as shown

Inboard joint side

NOTE: Wrap the splines with vinyl tape to prevent

damage to the boot.

9. Install the inboard boot to the driveshaft, then

remove the vinyl tape.

10. Install the stop ring into the driveshaft groove.

11. Install the spider on the driveshaft by aligning the

marks on the spider and end of the driveshaft.

12. Install the set ring into the driveshaft groove.

INBOARD BOOT

Chapters

Table of Contents