Acura NSX 1997 Service Manual page 481

Main Menu
Shift Cable
Adjustment
1. Raise the vehicle (see
2. Shift to the position.
3. Remove the shift cable cover.
4. Remove the control lever pin and lock pin from the
control lever.
5. Shift the control lever to the
Table of Contents
section 1).
position.
6. Check that the hole in the control lever is perfectly
aligned with the hole in the shift cable.
7. If the hole is not perfectly aligned, loosen the lock-
nut on the shift cable and adjust if as needed.
8. Tighten the locknut.
9. Install the control lever pin and lock pin.
NOTE:
• If you feel the control lever pin binding as you
reinstall it, the cable is still out of adjustment and
must be readjusted.
• Install the lock pin as shown in step 4.
10. Install the shift cable cover.
11. Start the engine, and check the shift lever in all
gears. If any gear does not work properly, refer to
Troubleshooting on pages 14-98 thru 14-101.