Acura NSX 1997 Service Manual page 420

Table of Contents

Transmission

Make sure lifts are placed properly, and

hoist brackets are attached to correct position (see

CAUTION: Use fender covers to avoid damaging painted

Check and record the rear camber

Disconnect the battery negative (-) first, and

positive ( + ) cable from the battery.

Drain automatic transmission fluid (ATF).

Reinstall the drain plug with a new washer.

NOTE: Removing the ATF dipstick (yellow loop) will

allow the ATF to drain more rapidly.

Table of Contents

4. Remove the strut bar.

5. Remove the air cleaner housing.

6. Remove the connectors from the control box, and

remove the control box (see

Do not remove the vacuum tubes from

the control box.

7. Remove the wire harness holder, disconnect the

vehicle speed sensor (VSS) wire connectors,

solenoid valve wire connectors, starter motor

cables and transmission ground cable.

8. Remove the ATF cooler as it is connected by the

CAUTION: Do not remove the hoses from the ATF

9. Remove the starter motor mounting bolts, then

remove the starter motor.

10. Remove the transmission housing bolts and the

transmission mounting bolts.

Chapters

Table of Contents